Before You Call For Service - Fisher & Paykel DH8060P3 User Manual

User warnings
Your dryer is capable of diagnosing a number of its own problems. It will sound a
continuous series of beeps and display a user prompt when it has a problem that you can
correct yourself. To stop the beeps sounding, press any button on the control panel. Do not
try to continue your drying cycle once you stop the noise. You must address the problem
the dryer is alerting you to.
Check the below table before you call for service.
PROBLEM DISPLAYED AS
Keylock is
activated
The lint filter
is blocked
and needs to
be emptied
The water
tank is full
and needs to
be emptied
The door is
not closed
The drying
rack is not
in place
Once you have addressed the issue the user prompt was alerting you to, try using your
dryer as per usual. If the issue persists, call your Fisher & Paykel trained and supported
service technician.

BEFORE YOU CALL FOR SERVICE

WHAT TO DO
Press
Empty the lint filter and then replace it.
Check the lint filter is not damaged.
Check there is nothing else stuck in the lint filter holder
which may be blocking the air flow.
Check the lint filter is in place correctly in your dryer.
Clean the condenser filter and the foam filter (refer
to 'Caring for your dryer'). Ensure the foam filter has
been replaced correctly on the condenser filter. Ensure
the condenser filter unit has been placed or replaced
correctly into your dryer.
If the error continues you may need to replace the filter
foam, refer to 'Clean the filter foam' for details'.
Check if the water tank is full.
Empty the water tank.
If using the drain hose, check whether the water tank
or drain hose is blocked.
Check the drain hose is still attached at the back
of the dryer, and is not kinked or squashed.
Close the door fully and press
Try opening and closing the door again.
Reposition the load, ensure the load is correctly in the
drum and that protruding items are not preventing the
door from closing.
Fit the drying rack.
for two seconds to deactivate the .
KEYLOCK
.
37