Table of Contents
Advertisement
PROBLEM
Display will not
turn on
Display not
responding
Dryer does
not heat
Dryer will
not start
Dryer stops
and starts
Dryer stops
mid-cycle
Noises
TROUBLESHOOTING
POSSIBLE CAUSES
No power.
Dryer needs to be reset.
Software update may
be required.
Water tank is full.
The cycle is in the
phase.
COOLING
The door is not
properly closed.
Is the dryer displaying a user
warning or fault code?
Water tank is full or not
correctly in place.
Dryer is overloaded.
is set.
DELAYED START
The controls are locked.
is on.
WRINKLE FREE
Power failure.
Cycle has been paused.
Door is open.
Items fell off the rack
during
.
RACK DRY
Dryer is overloaded.
Dryer has a fault.
End of a cycle.
Dryer is not level.
Compressor noises.
WHAT TO DO
Ensure the dryer is plugged in and the
power supply is turned on at the wall.
Press the dial to turn the dryer off. Wait a
few seconds, then press the dial again to
turn the dryer back on.
If the problem persists, try turning the
dryer off and on again at the wall. The
display may take a few seconds to load.
If the dryer is connected to Wi-Fi, check
if any updates are available.
Ensure the water tank is empty. Refer to
'Water tank'.
This is normal. Wait for the cycle
to finish.
Ensure the door is firmly shut. Check lint
filter is not obstructing the door.
Refer to 'Fault codes'.
Ensure the water tank is empty and
correctly in place. Refer to 'Water tank'.
Remove some items from the dryer.
Refer to 'Cycle options'.
Press and hold the screen to unlock the
controls.
This is normal. Refer to 'Cycle options.'
Press
to resume the cycle.
Press
to resume the cycle.
Ensure the door is firmly shut.
Ensure the rack is installed correctly and
replace items on the rack.
Remove some items from the dryer.
Refer to 'Fault codes'.
and turn off alerts. Refer
Go to
SETTINGS
to 'Menu'.
Ensure the dryer is level. Refer to
installation guide.
This is normal. At the start of the cycle
the dryer may make some unfamiliar
noises when the compressor turns on.
29
Advertisement
Table of Contents
