Fisher & Paykel DH8060P3 User Manual page 13

If you connect the drain hose onto your dryer, the other end must be secured in a drain to
prevent water draining onto the floor. Ensure the drain hose is securely fixed in place to an
appropriate drain and is leak-free at the connection to the machine. Check the connection
and drain hose regularly.
Maximum standpipe height is 1.0m from ground level.
z
Regularly check that your standpipe or tub is free from lint and other obstructions,
z
which may affect drainage and cause flooding.
The drain hose should be checked from time to time and replaced if any damage,
z
eg wear, cuts, bulges, kinks, leaks, etc are found. Do not bend the drain hose sharply,
as this may cause it to split.
The extended length of the provided drain hose is 1.3m.
z
In multi-storey apartments or any upper floor, the machine should be installed on
z
a floor equipped with a drain.
Draining must comply with local by-laws.
z
Electrical connection
This dryer must be connected to a 220V – 240V, 50Hz, sinusoidal, 10A electrical supply.
z
Uncoil the power cord, remove and discard the plastic pin cover and plug into
z
a power socket.
Connect the dryer to an earthed outlet protected by a fuse of suitable capacity.
z
Check the power cord for damage and make sure it is not squashed or twisted
z
when installing the dryer.
Always remove the power cord from the power socket by the plug, not by the cord.
z
ELECTRICAL
Volts
Hz
Amps (maximum)
Power consumption (W)
SPARE PARTS*
Foam filter kit
Drain hose
*Available from your Fisher & Paykel dealer or a Fisher & Paykel trained
and supported service technician.
INSTALLATION INSTRUCTIONS
220 – 240
50
10
900
PART NO.
479832
479900
13