Fisher & Paykel DH8060P3 User Manual page 43

PROBLEM
Linting
Fabric damage
TROUBLESHOOTING
POSSIBLE CAUSES
Lint filter not cleaned
or replaced.
Loads not sorted correctly.
Clothes over dried.
New items have been dried
in the dryer recently.
New towels or flannelette
sheets can leave lint in the
dryer, which may be picked
up by subsequent loads.
Instructions on care label
not followed.
selected
DRYNESS LEVEL
not appropriate for the
fabric type.
Metal parts on the items or
in the load.
Items not separated or
dried on an appropriate
cycle for the fabric type.
Items fell off the rack when
using .
RACK DRY
Used a cycle and did
TIME DRY
not monitor the dryness of
clothes during the cycle.
WHAT TO DO
Ensure the lint filter is cleaned after
every cycle and replaced correctly.
Refer to 'Cleaning the filters'.
Dry lint-giving items separately
from lint receivers. Also, dry similar
colours together, eg light coloured
items with light coloured items, dark
items with dark items.
Refer to 'Sorting', 'Lint'.
Over drying clothes in the dryer
can cause them to attract lint.
Use an auto sensing cycle or ensure
you check your load if using the time
dry cycles to avoid over drying.
Refer to 'Drying cycles'.
Clean the lint filter and use
cycle to clear any remaining lint from
the dryer.
Follow the instructions on the
care label of the items.
Ensure the
DRYNESS LEVEL
is appropriate for the fabric type.
Refer to the items care label. Refer to
'Drying cycles'
Fasten zips and other clasps
before placing items in the dryer.
Dry similar items together.
Ensure an appropriate cycle is
selected. Refer to 'Drying cycles'.
Ensure the rack is installed correctly
(refer to 'Sorting', 'Drying rack') and
only one or two garments are placed
on the rack at a time.
Ensure that clothes are checked
for dryness during the cycle
when using the timed programmes
to avoid over drying.
Refer to 'customising drying cycle'.
COOL AIR
selected
43