Liability; Ce Conformity; Warranty; Trademarks - Otto Bock Start M1 Instructions For Use Manual

Using the product beyond the specified expected service life leads to increased residual risk and should only take
place subject to the due diligence and deliberations of qualified personnel.
If the service life is reached, the user or a responsible attendant should contact the qualified personnel who fitted
the product or the manufacturer's servicing department (see inside rear cover or back page for address). Here the
user can obtain information about known risks and the current options for refurbishing the product.

9.2 Liability

The manufacturer will only assume liability if the product is used in accordance with the descriptions and instruc­
tions provided in this document. The manufacturer will not assume liability for damage caused by disregard of this
document, particularly due to improper use or unauthorised modification of the product.

9.3 CE Conformity

This product meets the requirements of the European Directive 93/42/EEC for medical devices. This product has
been classified as a class I device according to the classification criteria outlined in Annex IX of the directive. The
declaration of conformity was therefore created by the manufacturer with sole responsibility according to Annex VII
of the directive.

9.4 Warranty

Further information on the warranty terms and conditions can be obtained from the qualified personnel that has fit­
ted this product or the manufacturer's service (see inside back cover for addresses).

9.5 Trademarks

All product names mentioned in this document are subject without restriction to the respective applicable trade­
mark laws and are the property of the respective owners.
All brands, trade names or company names may be registered trademarks and are the property of the respective
owners.
Should trademarks used in this document fail to be explicitly identified as such, this does not justify the conclusion
that the denotation in question is free of third-party rights.

10 Appendices

10.1 Technical data

INFORMATION
► Many of the technical data below are given in mm. Please note that product settings – unless otherwise spe­
cified – cannot be adjusted in the mm range but only in increments of approx. 0.5 cm or 1 cm.
► Note that the values achieved during adjustment may deviate from the values specified below. The deviation
can be ±10 mm and ±2°.
General information
Max. load capacity (in kg)
Weight [kg]
(for seat width of 430 mm)
Transport weights [kg]
(for seat width of 430 mm)
Seat width [mm]
Seat depth [mm]
Max. total height [mm]
(for rear seat height: 470 mm; back height 400 mm; push
handle)
Turning circle approx. [mm]
(for seat width of 430 mm and seat depth of 420 mm)
Maximum permissible inclination [°]
Maximum permissible inclination [%]
1)
The specified weights vary according to the selected options and model.
2)
in accordance with ISO 7176-5, 8.12
3)
An anti-tipper is required for inclinations of more than 7° (12 %).
Start M1
Start M1
125
1)
from approx. 14.7
1)
frame: from approx. 9.7
1)
Footrest: approx. 1.4
Rear wheels 24" (pair): approx. 3.6
380/405/430/455/480/505
2)
400/420
945
2)
1400
3)
7
3)
12
Appendices
1)
2)
Ottobock | 29