Preparation For Use; Assembly - Otto Bock Start M1 Instructions For Use Manual

5 Preparation for Use

5.1 Assembly

CAUTION
Exposed pinch points
Crushing, pinching due to incorrect handling
► When folding the wheelchair out or together, only grip by the specified components.
CAUTION
Failure to verify readiness for use before putting into operation
Tipping, falling due to incorrect adjustment or installation
► Before you start using the wheelchair for the first time, check the chosen wheelchair settings with the support
of authorised personnel.
► After every assembly, check for proper mounting of the rear wheels. The quick-release axles must be securely
locked in the receiver bushings.
► Pay particular attention to the stability against tipping, free running of the rear wheels and correct function of
the wheel locks.
INFORMATION
On the topic of disassembly/transport: see Page 24.
A few simple steps are sufficient for preparing the wheelchair for use:
1) Attach the rear wheels to the quick-release axle housings (see fig. 2):
→ Press in the button on the quick-release axle.
→ Attach the rear wheel to the quick-release axle housing and release the button on the quick-release axle.
→ The quick-release axles must not be able to be removed after the push-button has been released.
2) Unfold the wheelchair (see fig. 3).
3) Attach the footrests (see Page 13).
4) If required: pull the part of the flap that can be fastened forwards and fasten tightly to the seat upholstery (see
fig. 4).
5) If necessary: Fit the seat cushion. The seat cushion is secured against sliding by being pressed on to the
hook-and-loop fastener (see Page 15).
2
Start M1
3
Preparation for Use
Ottobock | 11