Usb Connection - NewMar Commander II Series Manual

1. Connect the communicating device to the J305 Ethernet port inside the energy manager.
2. Open an internet browser such as Edge, Chrome, Firefox or similar on the device.
3. Enter the Ethernet default IP address into the internet browser.
N : the energy manager IP address can be located from the front panel LCD menu under:
OTE
Settings>Networking>Ethernet.
4. The energy manager log in page appears.
5. Enter the user name and password. See
7.3

USB Connection

Figure 17: 3U EM4x-01 Front Panel micro-USB
Micro-USB
1. Connect the communicating device to the micro-USB port on the front of the energy manager. See
Figure 17.
A driver installation prompt appears.
2. Double-click the appropriate USB driver (32bit or 64 bit).
3. Follow the installation wizard instructions to install the driver.
4. Open an internet browser such as Edge, Chrome, Firefox or similar.
5. Enter the USB default IP address into the internet browser: 172.31.250.1
6. The energy manager log in page appears.
6. Enter the username and password. See
Note: USB connection to the energy manager is possible without AC, battery or other external power supply.
The EM4x operates drawing power through the USB port. However, USB supply does not power the IO Board.
NewMar Power System Manual
Model: COMMANDER II AND COMMANDER II+
7.1 Access Levels.
7.1 Access Levels.
Ethernet Port
M-CMDRII 063022 Page 18 of 43
Version 1.0