Table of Contents
Advertisement
Failure to correctly follow the items below may cause incorrect system functionality and, in some cases, ruin your battery
(without the ability to claim battery replacement under warranty).
N
: Any values shown below are indicative only. If the values in your system differ from those shown
OTE
here, write in the values relevant to your system.
Refer to the EM4x energy manager manual for more details.
11.3.1 Check the Battery Type
The system MUST be configured to the correct battery type.
EM4x Web UI page Battery>Battery Settings
11.3.2 Modular Smart Lithium Battery Selection
If the system is connected via Modbus RTU to a battery BMS check the correct specific battery is selected from the Product
drop down list and mapped to the correct address. EM4x Web UI page: IO Configuration>Modbus Master>Device Map
11.3.3 Check/Set Float Voltage
Consult the battery manufacturer's data for the proper setting. Note that the float voltage directly impacts the state of
health of batteries after multiple cycles. The consequences of the float voltage setting must be understood.
The Float voltage is for 25°C reference temperature in NewMar systems.
EM4x Web UI page: Control Example:
Site Setting:
Appendix I R
ECTIFIER
I.A Rectifier Input Fuse Characteristics
The NewMar RM3048HE rectifier uses two Conquer UDA-A 025 fuses in its input, one on each phase/line of the AC input.
N
: The curves are for average value, for reference only.
OTE
Figure 19: Rectifier Input Fuse Tripping Curves
Technical Service: 800-241-3897 • E-mail: techservice@newmarpower.com
F
USE AND FRONT PANEL BEHAVIOUR
Newmar • 1580 Sunflower Ave, Suite 100, Costa Mesa, CA 92626
Done
Done
Done
Advertisement
Table of Contents
