Table of Contents
Advertisement
1.
Connect the communicating device to the J305 Ethernet port inside the energy manager.
2.
Open an internet browser such as Edge, Chrome, Firefox or similar on the device.
3.
Enter the Ethernet default IP address into the internet browser.
N
: the energy manager IP address can be located from the front panel LCD menu under:
ote
Settings>Networking>Ethernet.
4.
The energy manager log in page appears.
5.
Enter the username and password. See
6.3.
USB Connection
Figure 17: 1U EM4x-01 Front Panel micro-USB
1.
Connect the communicating device to the micro-USB port on the front of the energy
manager. See
Figure
A driver installation prompt appears.
2.
Double-click the appropriate USB driver (32bit or 64 bit).
3.
Follow the installation wizard instructions to install the driver.
Micro-USB
4.
Open an internet browser such as Edge, Chrome, Firefox or similar.
5.
Enter the USB default IP address into the internet browser: 172.31.250.1
6.
The energy manager log in page appears.
6. Enter the username and password. See
Note: USB connection to the energy manager is possible without AC, battery or other
external power supply. The EM4x operates drawing power through the USB port. However,
USB supply does not power the IO Board. In this scenario there is a set of alarms that display
depending on the system configuration relating to the nonoperation of the IO board.
For example:
Newmar • 1580 Sunflower Ave, Suite 100, Costa Mesa, CA 92626
Phone: 714-751-0488 • E-mail: techservice@Newmarpower.com
7.1 Access
17.
7.1 Access
Levels.
Levels.
13
Advertisement
Table of Contents
