Table of Contents
Advertisement
1.12
Post-mate Connection
The rectifier is "hot plug" capable. This is achieved by having one pin on the rear connector that mates after the
other pins. This pin must be connected to negative bus volts and the rectifier will not start until this pin engages. If a
rectifier will not start, ensure the rectifier is fully engaged in the Goldfish connector in the rectifier shelf.
1.13
Interface – Rear Connector
The rear connector on the rectifiers is a Positronic® Goldfish GFSH109 series.
Pin descriptions
Pin #
Description
Pin 1,2,3
Positive Output
Pin 4,5,6
Negative Output
Pin 7
Serial Communication Bus
Pin 8
Rack Position – horizontal
Pin 9
Rack Position – vertical
Pin 10
Post-mate – connected to negative output
Pin 11
Load Share
Pin 12
Not Assigned
Pin 17
AC protective Earth
Pin 18
AC live (phase) conductor
Pin 19
AC neutral conductor
Note: Unassigned pins should not be connected to anything and should
be left isolated and voltage free.
2 Installation
2.1
General Warnings
This rectifier contains no user serviceable components. Do not disassemble the rectifier.
To isolate the rectifier from the mains power, simply unplug from the rack or switch off at the distribution panel.
Rectifier Installation Manual
Page 6 of 10
Advertisement
Table of Contents
