Sun Microsystems SPARCstation 2 Service Manual page 107

Note – Bank 0 must be filled with SIMMs or the system will not pass its power-
on self test.
12. Re-install the SBus boards as directed in "SBus Boards" earlier in this
chapter.
13. Connect all of the cables to the ports at the rear of the system unit.
14. Replace the system unit's top cover.
See "Replacing the System Unit's Cover" later in this chapter.
15. Turn the system unit's power on, and check for proper system operation.
See "How to Turn the Power Back On" at the end of this chapter.
FRU Replacement
4
91