Board Specification - Renesas RZ/T2M User Manual

Renesas Starter Kit+ for RZ/T2M
1.3

Board specification

Board specification is shown in Table 1-1 below.
Item
Microprocessor
On-Board Memory
Input Clock
Power Supply
Debug Interface
DIP Switch
Push Switch
Potentiometer (for ADC)
LED
Ethernet
CAN
*2
USB
RS485
USB to Serial Converter Interface
Pmod™
mikroBUS™
Grove ®
QWIIC ®
Pin Header *3
Application Board Interface *3
*1 : Access frequency of SRAM is up to 50MHz on this board.
*2 : The CAN on this board can transfer at up to 5Mbps.
: This part is not mounted.
*3
R20UT4939EG0100 Rev. 1.00
Apr 20, 2022
Table 1-1: Board Specification
Specification
Part No: R9A07G075M24GBG
Package: 320-pin FBGA
On-Chip Memory: RAM 2MB
SDRAM: 256Mbit (Data width 16bit)
NOR Flash: 256Mbit (Data width 16bit)
Octa Flash: 512Mbit
HyperRAM: 64Mbit
QSPI Serial Flash: 512Mbit
I 2 C EEPROM: 16Kbit
RZ/T2M Main: 25MHz
RL78/G1C Main: 12MHz
Ethernet PHY (for RGMII): 25MHz
DC Power Jack: 5 V Input
USB Type-C Connector: 5V Input
Power Supply IC: 5V Input, 3.3V Output
Power Supply IC: 5V Input, 1.8V Output
Power Supply IC: 5V Input, 1.1V Output
Power Supply IC: 5V Input, 1.0V Output (For Ethernet PHY)
Power Supply IC: 5V Input, 2.5V Output (For Ethernet PHY)
MIPI-10: 1.27mm pitch 10-pin header
MIPI-20: 1.27mm pitch 20-pin header
Mictor-38: 0.64mm pitch 38-pin header
J-Link ® OB: USB-MicroB
Mode Configuration: 10-pole x 1
Signal Select: 10-pole x 2
User: 8-pole x 1
Reset Switch x 1
User Switch x 3
Single-turn, 10kΩ
3.3V Power Indicator: green x 1
User: green x 1, yellow x 1, red x 2
Ethernet Status: green x 3, yellow x 3
Ether-CAT Status: green x 4, yellow green x 1, red x 3
J-Link ® OB Status: yellow x 1
Connector: RJ45 x 3
PHY: Single Port PHY x 3
Connector *3 : 2.54mm pitch, 3-pin x 1
CAN Driver x 1
USB-Function: Mini-USB
USB-Host: USB-Type A
Connector : 10-pin Connector
*3
RS485 Transceiver x 1
Connector: Mini-USB
Driver: RL78/G1C Microcontroller (Part No R5F10JBCAFP)
PMOD-2A, 6A: 12-pin Connector
PMOD-3A: 12-pin Connector
2.54 mm pitch, 8-pin x 2 (J21, J22)
2.00 mm pitch, 4-pin x 2 (J27, J28)
1.00 mm pitch, 4-pin x 1 (J30)
2.54 mm pitch, 20-pin x 2 (CN1, CN3), 2.54mm pitch, 8-pin x 1 (CN2)
2.54 mm pitch, 26-pin x 2 (JA1, JA2), 50-pin x 1 (JA3), 24-pin x 2 (JA5, JA6)
*1
1. Overview
Page 10 of 87