Renesas RZ/T2M User Manual page 33

Renesas Starter Kit+ for RZ/T2M
6.2.4 Traditional Pin Header Jumpers
These jumpers are traditional small pitch jumpers that require an external shunt to open/close them.
following table describes the default settings for traditional pin header jumpers on the CPU board.
Reference
CN8 Short 1-2
Short 2-3
CN17 Short 1-2
Short 2-3
CN18
Short 1-2
Short 2-3
CN19 Short 1-2
Short 2-3
CN20 Short 1-2
Short 2-3
Short 1-2
CN21
Short 2-3
CN22 Short 1-2
Short 2-3
CN23 Short 1-2
Short 2-3
J9 Open
Short
R20UT4939EG0100 Rev. 1.00
Apr 20, 2022
Table 6-2: Default Pin Header Jumper Settings
Jumper Position
When using Octa Flash
When using QSPI Serial Flash
When using VCC1833_2 domain at 3.3V
When using VCC1833_2 domain at 1.8V
When using 3 ports in the same PHY mode
When ports 0 and 1 use the same PHY mode and port 2 uses different PHY modes
When using 3 ports in the same PHY mode
When ports 0 and 1 use the same PHY mode and port 2 uses different PHY modes
When using 3 ports in the same PHY mode
When ports 0 and 1 use the same PHY mode and port 2 uses different PHY modes
When using the RS485 transmission method in full duplex
When using the RS485 transmission method in half duplex
When using the RS485 transmission method in full duplex
When using the RS485 transmission method in half duplex
When not using CS5#
When using CS5#
When using the J-Link
When using the external emulator or not using the emulator
Explanation
OB
®
6. Configuration
The
Page 33 of 87