Table of Contents
Advertisement
Figure 3-21 Installing a Communications Interface module in an ONS 15252 MCU
Procedure: Install the Client Layer Interface Port Module in the ONS 15252 MCU
Step 1
Align the CLIP module with a CLIP module slot in the MCU. Install CLIP modules from left to right.
Step 2
Carefully insert the CLIP module into the slot. Be sure the CLIP module connector and the backplane
connector mate correctly.
Step 3
Tighten the CLIP module thumbscrews.
Repeat Steps
Step 4
Step 5
Install a CLIP module slot cover for each empty CLIP module slot.
Figure 3-22
Cisco ONS 15200 Installation, Setup, and Test Manual
3-30
1–3
for each CLIP module in the ONS 15252 MCU.
illustrates an ONS 15252 MCU with three CLIP modules installed.
Chapter 3
Installation
78-13765-01
Advertisement
Table of Contents
