STEP 17. CONFIGURE HOSE
ROUTING
The header drive hose routing depends on the
windrower model to which the header is being
attached.
A
a. Press screwdriver against latch in opening (A),
and lift to open header LH drive shield. Shield
will latch at (B) to stay open.
b. Check hose routing at the reel motor.
c. Disconnect hoses as follows:
D
E
M150/M200 - FACTORY CONFIGURATION
1. Disconnect hose (C) at tee.
2. Disconnect hose (D) at reel motor.
3. Disconnect tee (E) at motor lower port.
Form 169078
UNLOADING AND ASSEMBLY
B
C
d. Re-connect hoses as follows:
D
C
1. Relocate tee (E) to upper port.
2. Connect hose (D) to tee.
3. Connect hose (C) to motor lower port.
e. Close drive shield before engaging header.
STEP 18. REPOSITION WOBBLE
BOX BREATHER
BETWEEN LOWER HOLE
CHECK OIL LEVEL WITH TOP OF WOBBLE BOX
a. Move breather/dipstick (B) to back port, and
install plug (A) in forward port at wobble box(es).
b. Check oil level. Add SAE 85W-140 lubricant if
required.
34
E
M100/M205
AND END OF DIPSTICK
HORIZONTAL
B
A
Revision C