A40-D Double Knife - MacDon A30-S Assembly Instructions Manual

f. Open shield on header LH side.
J
g. Sickle drive belt (J) should deflect 0.55 inch
(14 mm) when a load of 5 - 6.5 lbf (22 - 30 N) is
applied at mid-span).
h. Auger drive chain (K) deflection should be
¼ inch (6 mm).
i. Auger drive belts (L) should deflect 3/16 in.
(4 mm) when a load of 8 - 12 lbf (35 - 40 N) is
applied to each belt at mid-span.
j. Close shield.
k. Proceed to Section 20B. AUGER STRIPPER
BAR CLEARANCE.
Form 169078
PRE-DELIVERY CHECKS
L
K
A30-D
III. A40-D DOUBLE KNIFE
a. Open shield on header RH side.
b. Sickle drive timing belt (M) should deflect
0.55 inch (14 mm) when a load of 5 - 6.5 lbf
(22 - 30 N) is applied at mid-span).
c. Open shield on header LH side.
d. Sickle drive timing belt (N) should deflect
0.55 inch (14 mm) when a load of 5 - 6.5 lbf
(22 - 0 N) is applied at mid-span).
e. Sickle drive V-belts (O) should deflect 3/16 in.
(4 mm) when a load of 8 - 12 lbf (35 - 40 N) is
applied to each belt at mid-span.
f. Close shields.
45
M
A40-D
N
A40-D
Revision C
O