Auger Stripper Bar Clearance; Reel Tine To Header Pan Clearance - MacDon A30-S Assembly Instructions Manual

B. AUGER STRIPPER BAR
CLEARANCE
a. Check for signs of auger flighting rubbing
stripper bars after run-up.
1/32 - 5/32 in.
(1 - 4 mm)
CLEARANCE
1/32 - 5/32 in.
(1 - 4 mm)
CLEARANCE
b. Check clearance between auger flighting and
stripper bars.
The auger should clear the stripper bars
on the auger pan by approximately
1/32 - 5/32 in. (1 - 4 mm). Shimming the
stripper bars may be required.
Form 169078
PRE-DELIVERY CHECKS
1/32 - 5/32 in.
(1 - 4 mm)
CLEARANCE
NOTE
C. REEL TINE TO HEADER PAN
CLEARANCE
0.08 - 0.39 in.
(2 - 10 mm)
The above dimensions are provided as
guidelines only.
contact the guards but not the knife
sections or the auger pan.
a. Rotate reel slowly by hand, and check tine
clearance at knife and pan.
simulate crop-loaded position to ensure tine
clearances to knife sections and auger pan are
AUGER
adequate for working conditions.
b. Check that the reel rotates freely.
In order to set the reel as close as
possible to the knife and pan, it may be
necessary to trim a small number of tines
that appear exceptionally long.
46
FLEX TINE BACK
0.08 in.
(2 mm)
IMPORTANT
Tines may "slightly"
Flex tines to
NOTE
Revision C