Step 7. Install Tall Crop Divider - MacDon A30-S Assembly Instructions Manual

STEP 7. INSTALL TALL CROP
DIVIDER
If kit is not supplied, proceed to STEP 8. ADJUST
LEAN BAR. Otherwise proceed as follows:
a. Remove hardware on both sides of lean bar,
and remove lean bar.
D
b. Attach extensions (C) to lean bar with four bolts
(D) and nuts provided.
c. Re-attach lean bar to header with existing
hardware at desired location. Tighten bolts.
Form 169078
UNLOADING AND ASSEMBLY
d. Attach LH divider assembly (E) to LH end of
e. Install U-bolt (H), and tighten all bolts.
C
f.
14
E
G
F
lean bar with two bolts (F) and nuts provided.
The divider may be positioned as shown, or
using the optional mounting hole (G).
Repeat for RH divider.
H
Revision C