Step 6. Remove Shipping Stands - MacDon A30-S Unloading And Assembly Instructions

D
C
h. Remove lynch pin from clevis pin (C) in header
stand at right side of header.
i. Hold stand (D), and remove clevis pin (C).
C
j. Invert stand (D), and re-install on header leg in
upper hole location with clevis pin (C). Secure
clevis pin (C) with lynch pin.
In soft conditions use a wooden block
under the stand.
k. Lower header onto stand (D).
169078
UNLOADING AND ASSEMBLY
D
NOTE
STEP 6. REMOVE SHIPPING
STANDS
F
a. Remove two bolts (E) from shipping stand (F).
b. Remove hairpin from pin (G).
c. Hold shipping stand (F), remove pin (G), and
remove stand. Discard stand and hardware.
d. Repeat above steps for opposite shipping stand.
J
e. Remove four bolts (H), and remove angle (J).
Discard angle and hardware.
12
E
G
H
Revision E