Removing And Replacing The Cisco 7505 Power Harness Cover - Cisco 7500 Series Configuration Manual

Chapter 5 Maintaining Your Cisco 7505 Router
Use the following procedure to replace the fan tray:
Step 1 Replace the fan tray. Hold the fan tray assembly in the position shown in
straight as possible, or you might have trouble inserting it into the chassis.
Note Before inserting the fan tray, compare the hardware inside the chassis to
bottom of the fan tray has to slide along in the track on the floor. At the same time, the runner on the top
of the tray has to slide through the notch at the top of the chassis opening, then over the top of the card
cage while staying to the left of the L-bracket on the chassis ceiling.
Step 2 Insert the top runner of the fan tray through the notch in the top of the chassis. Continue pushing the tray
into the chassis, ensuring that the bottom runner slides into the track on the floor of the chassis. If the
tray hangs up, pull it back out a few inches and try pushing it back in again. If the runners seem to be
catching on the brackets, push the tray slightly toward the left when inserting it again.
Slide the tray back into the chassis, pushing it all the way in until the circuit board snaps into the
Step 3
backplane socket.
Replace the M4 screw in the tab and tighten it with a number 2 Phillips screwdriver. (See the cutaway
Step 4
view of this screw in
Replace the cover panel. (Follow Step 1 through Step 4 in the procedure for replacing the cover panel in
Step 5
the
This completes the fan tray replacement procedure.

Removing and Replacing the Cisco 7505 Power Harness Cover

You must remove the power harness cover to access the power supply. A single M3 Phillips screw
secures the power harness cover to the backplane cover.
Warning Before working on the chassis or near power supplies, disconnect the power cable on AC units or
disconnect the power at the circuit breaker on DC units.
Use the following procedure to remove the power harness cover:
Step 1 Turn off the system power switch and disconnect the power cable from the power source.
Step 2 Remove the chassis cover panel. (Follow Step 1 and Step 2 in the procedure for removing the chassis
cover panel in the
OL-5008-03 B0
Figure 5-2.)
"Removing and Replacing the Cisco 7505 Cover Panel" section on page
"Removing and Replacing the Cisco 7505 Cover Panel" section on page
Maintenance Procedures for the Cisco 7505
Figure
Cisco 7500 Series Installation and Configuration Guide
Figure 5-2. Keep the tray as
5-3. The runner on the
5-3.)
5-3.)
5-7