Attaching The Cisco 7513, Cisco 7513-Mx, And Cisco 7576 Cable-Management Bracket - Cisco 7500 Series Configuration Manual

Installing the Cisco 7513, Cisco 7513-MX, and Cisco 7576
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
Replace the card cage assembly. (See the procedure in the
Step 4
on page
Replace the power supplies. (See the
Step 5
Supplies" section on page
Replace the processor modules in the card cage. (See the procedure in
Step 6
levers and ensure the processor modules are securely installed; tighten any that are loose.
This completes the procedure for installing the Cisco 7513, Cisco 7513-MX, and Cisco 7576. Proceed
to the
on page
Attaching the Cisco 7513, Cisco 7513-MX, and Cisco 7576 Cable-Management
Bracket
Use the following procedure to install the cable-management bracket. You will need a large flat-blade
screwdriver for this procedure.
Locate the two slotted screws between the blower module and the card cage opening at the interface
Step 1
processor end of the router. (See
Figure 3-16
Blower
module
Loosen
screws (2)
Bracket
Card cage
Step 2 Loosen these two screws using the flat-blade screwdriver.
Place the bracket over the screws, as shown in
Step 3
Tighten the screws.
Step 4
Cisco 7500 Series Installation and Configuration Guide
3-26
7-9.)
3-27.)
"Attaching the Cisco 7513, Cisco 7513-MX, and Cisco 7576 Cable-Management Bracket" section
3-26.
Installing the Cable-Management Bracket on a Cisco 7513, Cisco 7513-MX, and
Cisco 7576
"Installing the Card Cage Assembly" section
"Installing Cisco 7513, Cisco 7513-MX, and Cisco 7576 Power
Figure 3-16.)
Figure 3-16.
Chapter 3 Installing a Cisco 7500 Series Router
Figure 3-14.) Check all ejector
OL-5008-03 B0