Cisco 7500 Series Configuration Manual page 142

Installing the Cisco 7513, Cisco 7513-MX, and Cisco 7576
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
Figure 3-17
Step 4 While firmly pressing the power supply faceplate so that is flush with the chassis rear panel, use a large
slotted screwdriver to tighten the captive screw that secures the power supply to the chassis frame.
Figure 3-18
Step 5 For AC-input power supplies—push the cable retention clip away from the power receptacle, and plug
in the power cable.
Note
Secure the cable in the power supply receptacle by pushing the cable retention clip until it snaps into
Step 6
place around the cable connector.
After the AC power cable is connected, reconnect the power cable at the power source, remove the tape
Step 7
(if any) that you placed on the breaker switch, but do not turn on the breaker or power to the power
supply.
Cisco 7500 Series Installation and Configuration Guide
3-28
Handling a Power Supply (Cisco 7513, Cisco 7513-MX, and Cisco 7576 AC-Input Power
Supply Shown)
AC
FAN
OK OUT PUT
OK
FAI L
Installing a Power Supply (Cisco 7513, Cisco 7513-MX, and Cisco 7576 AC-Input
Power Supply Shown)
AC
FAN OUTPUT
OK
OK FAIL
AC
FAN
OK
OK
Captive screws
For DC-input power supplies, proceed to the
7513-MX, and Cisco 7576 DC-Input Power Supplies" section on page
with Step 6.
OUTPUT
FAIL
POW ER
B
"Connecting Power to Cisco 7513, Cisco
Chapter 3 Installing a Cisco 7500 Series Router
3-29; otherwise, continue
OL-5008-03 B0