Cisco 7500 Series Configuration Manual page 122

Installing the Cisco 7505
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
The following guidelines are provided to ensure your safety:
–
–
–
Figure 3-4
Figure 3-4
A
B
C
Cisco 7500 Series Installation and Configuration Guide
3-8
Mount this unit at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with
the heaviest component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or
servicing the unit in the rack.
illustrates the Cisco 7505 rack-mount procedure.
Rack-Mounting the Cisco 7505
18.312"
(46.51 cm)
hole centerline
to hole centerline
17.72" min.
(45 cm)
Mounting strip
10-32 x 3/8-inch screws (8)
Chapter 3
Rack-mount the chassis as follows:
1. Measure the space between the vertical
mounting strips on your rack. Verify that your
rack conforms to the measurements
(shown in A).
Mounting strip
2. Use the four M4 x 10-mm screws provided
to attach the ears to the sides of the chassis
(shown in B). Use two screws per ear.
M4 x 10-mm screws (4)
Ears (2)
3. To prevent injury, have someone help you
install the chassis in the rack (shown in C).
Use the 10-32 x 3/8-inch screws provided to
attach the ears to the mounting strips. Use four
screws per ear and mounting strip. Level the
chassis as required. Provide 2 inches of
clearance on each side of the chassis.
Installing a Cisco 7500 Series Router
OL-5008-03 B0