Cisco 7500 Series Configuration Manual page 196

Maintenance Procedures for the Cisco 7505
Figure 5-9
Phillips screws
(2 places)
Backplane
power
receptacle
Disconnect the power harness plug from the backplane receptacle by pulling the polarized plug out of
Step 5
the receptacle; do not pull on the wires. (See
Use a number 2 Phillips screwdriver to remove the two M4 Phillips pan-head screws that secure the
Step 6
power supply ears (one on each side of the power supply) to the chassis frame. (See
Using both hands, grasp both of the power supply handles and pull the power supply about halfway out
Step 7
of the bay. (See
Figure
This completes the power supply removal procedure.
Cisco 7500 Series Installation and Configuration Guide
5-14
Removing and Replacing the Cisco 7505 Power Supply
Power harness
a
b
Removing/replacing
power supply
c
Figure 5-9b.) Then grasp the sides of the power supply and pull it out of the chassis. (See
5-9c.)
Power supply ears
Handling the
power supply
Figure 5-9a.)
Chapter 5 Maintaining Your Cisco 7505 Router
Figure 5-9a.)
OL-5008-03 B0