Installing The Cisco 7505 - Cisco 7500 Series Configuration Manual

Installing the Cisco 7505

R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
After you ensure that your site environment meets all guidelines, choose from the following sections
depending on the Cisco 7500 series model you plan to install:
•
•
•
Then see the
Installing the Cisco 7505
This section provides procedures for installing, rack-mounting, and attaching the cable-management
brackets on a Cisco 7505, and for connecting a power cable to the power supply.
Figure 3-2
Cisco 7505 router and attach external cables to it. It also indicates the Cisco publications you should
refer to for more detailed information.
Figure 3-2
For more information about configuration,
Depending on your configuration, you might need to insert additional or new processor modules in your
Cisco 7505. To insert or remove interface processors, you do not need to turn off power to the system.
However, you must turn off the system power before you insert or remove the RSP2, RSP4, or RSP8.
Cisco 7500 Series Installation and Configuration Guide
3-4
Installing the Cisco 7505, page 3-4
Installing the Cisco 7507 and Cisco 7507-MX, page 3-11
Installing the Cisco 7513, Cisco 7513-MX, and Cisco 7576, page 3-19
"What Do I Do Now?" section on page
shows a flowchart that illustrates the recommended order of procedures to install the
Installation Flowchart (Cisco 7505)
Unpack the router
Rack-mount the router
(optional)
Install additional processor
modules as required
Make external connections
Perform an initial configuration and
create a basic configuration file. Use the
procedures in Chapter 4 "Performing
a Basic Configuration of the System."
refer to the Cisco IOS configuration
guides and command references.
Chapter 3 Installing a Cisco 7500 Series Router
3-33.
OL-5008-03 B0