Performing A Basic Manual Configuration Using The Setup Facility; Configuring The Global Parameters - Cisco 7500 Series Configuration Manual

Configuring the Cisco 7500 Series System
At the # prompt, enter the copy running-config startup-config command if you are running Cisco IOS
Step 3
Release 11.0 or later, or the write memory command if you are running a Cisco IOS release earlier than
11.0:
Hostname# copy running-config startup-config
Taking this step saves the configuration settings that the AutoInstall process created in the router. If you
fail to do this, your configuration will be lost the next time you reload the router.

Performing a Basic Manual Configuration Using the Setup Facility

If you do not plan to use AutoInstall, do not connect the router's serial (WAN) cable to the CSU/DSU.
This prevents the router from attempting to run the AutoInstall process. (The router will attempt to run
AutoInstall whenever you start it if the serial [WAN] connection is connected on both ends and the router
does not have a configuration stored in NVRAM.) It can take several minutes for the router to determine
that AutoInstall is not set up to a remote TCP/IP host.
Once the router has determined that AutoInstall is not configured, it will default to the setup facility. If
the serial (WAN) cable is not connected, the router will boot from Flash memory and go into the setup
facility.
Note You can run the setup facility any time you are at the enable prompt (#) by entering the setup command.

Configuring the Global Parameters

When you first start the setup program, you must configure the global parameters, which are used for
controlling system-wide settings.
Use the following procedure to enter the global parameters:
Connect a console terminal to the console port on the RSP, and then boot the router to the user EXEC
Step 1
prompt (
two DB-25 male plug ends of the Y-cable.
When you have booted from Flash memory, the following information will appear after about 30
Step 2
seconds. When you see this information displayed, you have successfully booted your router:
System Bootstrap, Version 5.3(16645) [biff 571], RELEASED SOFTWARE
Copyright (c) 1994-1995 by cisco Systems, Inc.
This RSP2 is system master
Other RSP2 is not plugged in
RSP2 processor with 16384 Kbytes of main memory
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
Cisco 7500 Series Installation and Configuration Guide
4-12
). If you are using the console Y-cable that shipped with your router, use either of the
Router>
Chapter 4 Performing a Basic Configuration of the System
OL-5008-03 B0