Installing And Upgrading Field Replaceable Units; Removing And Replacing The Chassis Cover - Cisco 5100 Series Hardware Installation Manual

Installing and Upgrading Field Replaceable Units

•
•
•
•

Removing and Replacing the Chassis Cover

Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
These are the steps to remove the chassis cover:
Step 1 Confirm that the chassis is turned off and disconnected from the power supply or power supplies.
Step 2
Place the chassis on a flat surface.
Step 3 Remove the screws at top of the chassis cover.
Step 4
Remove the screws at the sides of the device as shown in the following figure.
Figure 10: Removing the Chassis Cover
Step 5 Lift the chassis cover after you have removed all the screws.
Removing and Replacing the Chassis Cover, on page 21
Installing a DIMM, on page 22
Removing a DIMM, on page 24
Upgrading the M.2 Storage Module, on page 25
Cisco 5100 Enterprise Network Compute System Hardware Installation Guide
4
C H A P T E R
21