Cisco 7500 Series Configuration Manual page 69

Chapter 1 Cisco 7500 Series Product Overview
Caution To prevent system problems, do not mix power supply input types in the Cisco 7507, Cisco
7507-MX, Cisco 7513, Cisco 7513-MX, or Cisco 7576 routers. Both power supplies installed in a
router must be either AC input or DC input. Do not attempt to install a DC-input power supply in a
router with one AC-input power supply, or vice versa.
The DC-input power cable is not available from Cisco Systems; however, it is available from commercial
cable vendors. DC-input power cable specifications are listed in
(Cisco 7507),
Table 1-6
For Cisco 7500 series routers used in North America, the following AC-input and DC-input power
supplies are available:
Cisco 7505—Product Numbers PWR/5AC(=) (see
•
Cisco 7507 and Cisco 7507-MX—Product Numbers PWR/7-AC(=) (see
•
PWR/7-DC(=) (see
Cisco 7513, Cisco 7513-MX, and Cisco 7576—Product Numbers PWR-7513-AC(=) and
•
PWR-7576-AC(=) (see
PWR-7576-DC(=) (see
Figure 1-24
On/off switch
AC receptacle
Cable retention
clip
Figure 1-25
Terminal block
(cover removed)
OL-5008-03 B0
Table 1-3 (Cisco 7507-MX),
(Cisco 7576).
Figure 1-27)
Figure 1-28); and Product Numbers PWR-7513-DC(=) and
Figure 1-29)
AC-Input Power Supply (Cisco 7505)
DC-Input Power Supply (Cisco 7505)
On/off switch
AC-Input and DC-Input Power Supply Overview
Table 1-1
Table 1-4 (Cisco 7513), Table 1-5
Figure 1-24) and PWR/5DC(=) (see
Cisco 7500 Series Installation and Configuration Guide
(Cisco 7505), Table 1-2
(Cisco 7513-MX), and
Figure 1-25)
Figure 1-26) and
DC OK LED
DC OK LED
1-47