Using location pins/shoulder:
7. Ensure the readhead is pushed back against the location pins or shoulder.
8. Tighten the fixing screws.
9. Check the readhead set-up LED is Green around the full axis of rotation.
10. Proceed with 'System calibration' section.
Not using location pins:
11. Adjust longitudinal and radial offset of the readhead to obtain a Green readhead set-up LED
around the full axis of rotation. An oscilloscope or Renishaw USB set-up tool kit and software
can be used to help maximise the signal size. For more information on the Renishaw USB
set-up tool kit contact your local Renishaw representative.
12. Tighten the readhead fixing screws.
13. Proceed with the
'System calibration'
section on page 34.
www.renishaw.com
31