Renishaw ATOM Installation Manual page 25

Ensure ferrule
is located
in housing
recess
4. Re-assemble the housing ensuring the cable ferrule is located in the recess on the inside and no wires are trapped.
5. Refit the screws.
6. When the system has been connected, proceed with
Disconnecting the readhead
1. Disconnect power.
2. Open the interface housing as detailed earlier in this section.
3. Gently lever the connector PCB (on the end of the cable) out of the socket.
4. Place the connector in an anti-static bag.
5. Re-assemble the interface.
'Readhead mounting and alignment' on page 28 and 'System calibration' on page 34.
www.renishaw.com 25