Manual Operation With Remote Control - SHOWTEC QubiQ S1000 User Manual

QubiQ S1000

Manual Operation with Remote Control

To set up the device, follow the steps below:
Fill the tank (Fluid Tank Capacity 1 L). See 6.3. Filling the Tank on page 22 for more information.
Connect the remote control cable to the device.
Connect the power cable before supplying power to the device. See 4.5. Connecting to Power
Supply on page 17 for more information.
Set the ON/OFF switch (08) to ON.
Wait for the device to heat up. This will take a maximum of 3 minutes.
When the device is not 100 % heated you cannot view the menu or change the settings.
To operate the device manually as a stand-alone device:
● Adjust the output volume in Output Vol menu. See 6.8.4.2. Output Volume on page 38 for more
information.
● Adjust the Interval volume in Interval menu. See 6.8.4.3. Interval on page 38 for more information.
● Adjust the Duration volume in Duration menu. See 6.8.4.4. Duration on page 38 for more information.
Notes:
● You cannot constantly fog @100 % until the tank is empty.
In order to constantly fog, you have to adjust the output volume to 40 %. Only then will the device
keep fogging until the tank is completely empty.
● The remote control always has priority over manual operation with the control panel on the device.
You are not able to use the buttons on the device, when the remote is plugged in.
Product code: 61060
34