KROHNE OPTIWAVE-M 7400 C Short Manual page 57

OPTIWAVE-M 7400 C
Menu Function
No.
C7.5.3 Volume
C7.5.4 Cst. Volume
C7.5.4.1 Text
C7.5.4.2 Offset
C7.5.4.3 Factor
C7.5.5 Mass
C7.5.6 Cst. Mass
C7.5.6.1 Text
C7.5.6.2 Offset
C7.5.6.3 Factor
C7.6 Factory Default
C7.6.1 Reset to Fact.
Def.?
1 If no value or parameter is specified in the customer order
2 "Lin. Distance" and "Lin. Level" are available if you created a linearized value table in menu C3 Conversion. "Volume" and "Ullage Vol- ume" are
available if you created a level-volume table in menu C3 Conversion. "Mass" and "Ullage Mass" are available if you created a level-mass table in
menu C3 Conversion.
02/2019 - MA OPTIWAVE-M 7400 C R01 en
Function description
The volume unit shown in Normal mode if you
made a volume table in the C3 Conversion
menu. If you set this menu item to "Cst.
Volume" (custom volume unit), enter values in
menu items C7.5.4.1 thru C7.5.4.3.
Minimum access level to change the
setting: User
Enter a text (8 characters maximum) for the
custom volume unit.
Enter an offset value.
Enter a factor. Multiply the measured value by
this factor to change m³ (cubic metres) to the
custom volume unit.
The mass unit shown in Normal mode if you
made a mass table in the C3 Conversion menu. If
you set this menu item to "Cst.
Mass" (custom mass unit), enter values in menu
items C7.5.6.1 thru C7.5.6.3.
Minimum access level to change the
setting: User
Enter a text (8 characters maximum) for the
custom volume unit.
Enter an offset value.
Enter a factor. Multiply the measured value by
this factor to change kg (kilogram) to the custom
mass unit.
If you set this menu item to "YES", the device
goes back to its initial settings (set by the
manufacturer in the factory).
Minimum access level to change the
setting: Expert
www.krohne.com
OPERATION
Selection list
m³, L, hL, in³, ft³, gal,
ImpGal, yd³, bbl, bbl (beer,
US), Cst. Volume
—
—
—
kg, t, lb, tn.sh., tn.l., Cst.
Mass
—
—
—
Yes, No
4
Marine Default
m³
Cst.
0.0 m³
1.0
kg
Cst.
0.0kg
1.0
No
57