KROHNE OPTIWAVE-M 7400 C Short Manual page 43

OPTIWAVE-M 7400 C
Menu Function
No.
B1.2.1 Current Output 1
B2 Actual Values
B2.1 Operating Time
[s]
B2.4 Level
B2.5 Distance
B2.6 Reflection
B2.7 Level Lin.
B2.8 Volume
B2.9 Mass
B2.10 Distance Lin.
02/2019 - MA OPTIWAVE-M 7400 C R01 en
Function description
This sets analogue output 1 to a test value
[mA]. Output will change to the selected
value, independent of the measured value.
When you push [^] to confirm the value,
the display shows the question "Start
Simulation?" Push [ ] or [ ] to set the
display to "Yes". Push [^] again to start
the test. The device goes to back to
Normal mode after 1 hour.
Minimum access level to do the
procedure: Expert
This is the total time that the device is
energized in seconds.
This menu item shows the level readings
measured at this time. This measurement
data is shown with the units set in menu
C7.5 Units.
This menu item shows the distance
readings measured at this time. This
measurement data is shown with the units
set in menu C7.5 Units.
This menu item shows the percentage of
the emitted radar signal which makes a
reflection on the surface of the tank
contents and is received by the device.
This menu item shows the level readings
(linearized) measured at this time. This
measurement data is shown with the units
set in menu C7.5 Units. This menu item is
only available if you set up a linearization
table in menu item C3.1 Edit Table.
This menu item shows the volume
readings measured at this time. This
measurement data is shown with the
units set in menu C7.5 Units. This menu
item is only available if you set up a
conversion (volume) table in menu item
C3.1 Edit Table.
This menu item shows the mass readings
measured at this time. This measurement
data is shown with the units set in menu
C7.5 Units. This menu item is only
available if you set up a conversion (mass)
table in menu item C3.1 Edit Table.
This menu item shows the distance
readings (linearized) measured at this
time. This measurement data is shown
with the units set in menu C7.5 Units. This
menu item is only available if you set up a
linearization table in menu item C3.1 Edit
Table.
www.krohne.com
OPERATION
Selection list
3.6. 21.5 mA
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
4
Marine
Default
1
—
—
—
—
—
—
—
—
43