Nwa1302-Ac - ZyXEL Communications NWA Series User Manual

Table 15 NWA1123-AC PRO LEDs (continued)
LED
Locator

3.4.2 NWA1302-AC

By default, the LEDs automatically turn on when the NWA1302-AC is ready. If the LEDs are turned off by
the NCC, you can press the LED ON button for one second to turn on the LEDs again. The LEDs will blink
and turn off after two minutes.
Figure 24 NWA1302-AC LEDs
The following table describes the LEDs.
Table 16 NWA1302-AC LEDs
LED
PWR/SYS
Chapter 3 Hardware
COLOR STATUS
White Blinking
Off
COLOR STATUS
Amber Blinks between amber
and green alternately
Green
(1 second interval).
Green On
Slow Blinking (On for 1
sec, Off for 1 sec)
Fast Blinking (On 50ms,
Off 50ms)
Red On
Fast Blinking (On for 50
ms, Off for 50 ms)
Slow Blinking (Blink for 3
times, Off for 3 sec)
NWA/WAC/WAX Series User's Guide
DESCRIPTION
The Locator is activated and will blink to show the actual
location of the Zyxel Device between several devices in the
network.
The Locator function is off.
DESCRIPTION
The LED blinks amber and green alternately when the
Zyxel Device is booting up.
The Zyxel Device is ready for use.
The wireless module of the Zyxel Device is disabled or
failed.
The Locator LED is on.
There is a system error and the Zyxel Device cannot boot
up, or the Zyxel Device suffered a system failure.
The Zyxel Device is doing firmware upgrade.
The Uplink interface is down.
53