ZyXEL Communications NWA Series User Manual page 59

Figure 27 WAC5302D-S LEDs
The following table describes the LEDs.
Table 19 WAC5302D-S LEDs
LED COLOR
PWR/SYS Amber
Green
Green
Red
Management Green
Chapter 3 Hardware
STATUS DESCRIPTION
Blinks between amber The LED blinks amber and green alternately when the
and green alternately WAC is booting up.
(1 second interval).
On The Zyxel Device is ready for use.
Slow Blinking (On for 1s, The wireless module of the Zyxel Device is disabled or
Off for 1s) failed.
Fast Blinking (On 50ms, The Locator LED is on.
Off 50ms)
On There is system error and the Zyxel Device cannot boot
up, or the Zyxel Device suffered a system failure.
Fast Blinking (On for The Zyxel Device is doing firmware upgrade.
50ms, Off for 50ms)
Slow Blinking (Blink for 3 The Uplink interface is down.
times, Off for 3s)
Slow Blinking (Blink for 2 The Zyxel Device is managed by an AC and the uplink is
times, Off for 3s) disconnected.
On The Zyxel Device is managed by a controller.
Slow Blinking (Blink for 3 The Zyxel Device is searching (discovery) for a controller.
times, Off for 3s)
Slow Blinking (On for 1s, The Zyxel Device is using default WiFi settings, or the Zyxel
Off for 1s) Device is connected to the NCC but is unregistered with
the NCC.
Off The Zyxel Device is in standalone mode.
NWA/WAC/WAX Series User's Guide
59