Nwa1302-Ac - ZyXEL Communications NWA1000 Series User Manual

3.1.4 NWA1302-AC

By default, the LEDs automatically turn on when the NWA1302-AC is ready. If the Suppression On option
is selected in the LEDs > Suppression screen (see
press the LED ON button for one second to turn on the LEDs again. The LEDs will blink and turn off after
two minutes.
Figure 8 NWA1302-AC LEDs
The following table describes the LEDs.
Table 5 NWA1302-AC LEDs
LED
PWR/SYS
Management
UPLINK
WLAN
Chapter 3 Hardware
COLOR STATUS
Red Slow Blinking (On for 1
sec, Off for 1 sec)
Green On
Green On
Slow Blinking (On for 1
sec, Off for 1 sec)
Red On
Fast Blinking (On for 50
ms, Off for 50 ms)
Slow Blinking (Blink for 3
times, Off for 3 sec)
Green/ Off
Amber
Amber/ On
Green
Blinking
Off
Green On
Off
NWA1000 Series User's Guide
Section 19.2 on page
DESCRIPTION
The LED blinks orange and green alternatively when the
NWA1000 Series is booting up.
The NWA1000 Series is ready for use.
The wireless module of the NWA1000 Series is disabled or
failed.
There is system error and the NWA1000 Series cannot
boot up, or the NWA1000 Series suffered a system failure.
The NWA1000 Series is doing firmware upgrade.
The Uplink port is disconnected.
The NWA1000 Series is in standalone mode.
Amber - The port is operating as a 10/100-Mbps
connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
The NWA1000 Series is sending/receiving data through
the port.
The port is not connected.
The 2.4 GHz WLAN is active.
The 2.4 GHz WLAN is not active.
23
183) to turn off the LEDs, you can