Ways To Access The Zyxel Device - ZyXEL Communications NWA Series User Manual

The following table describes the fields in the ZON Utility main screen.
Table 9 ZON Utility Fields
LABEL
Type
Model
Firmware Version
MAC Address
IP Address
System Name
Location
Status
Controller Discovery
Serial Number
Hardware Version
IPv6 Address

2.4 Ways to Access the Zyxel Device

You can use the following ways to configure the Zyxel Device.
Web Configurator
The Web Configurator allows easy Zyxel Device setup and management using an Internet browser. If
your Zyxel Device is managed by the NCC or an AC, use this only for troubleshooting if you cannot
connect to the Internet. This User's Guide provides information about the Web Configurator.
NCC
This is the primary means by which you manage the Zyxel Device in cloud (NCC) mode. With the NCC,
you can remotely manage and monitor the Zyxel Device through a cloud-based network management
system. See the NCC User's Guide for more information.
Chapter 2 AP Management
DESCRIPTION
This field displays an icon of the kind of device discovered.
This field displays the model name of the discovered device.
This field displays the firmware version of the discovered device.
This field displays the MAC address of the discovered device.
This field displays the IP address of an internal interface on the discovered device that
first received an ZDP discovery request from the ZON utility.
This field displays the system name of the discovered device.
This field displays where the discovered device is.
This field displays whether changes to the discovered device have been done
successfully. As the Zyxel Device does not support IP Configuration, Renew IP address
and Flash Locator LED, this field displays "Update failed", "Not support Renew IP
address" and "Not support Flash Locator LED" respectively.
This field displays if the discovered device supports the:
• AP controller discovery feature.
• Nebula Control Center (NCC) discovery feature.
If the feature is enabled, the selected device will try to connect to the AP controller/
NCC. If the selected device has successfully connected to an AP controller, it will
change to the AP controller managed mode. If the selected device has successfully
connected to the NCC and is registered on the NCC, it will change to the Nebula
cloud mode.
Enter the admin password of the discovered device to display its serial number.
This field displays the hardware version of the discovered device.
This field displays the IPv6 address of an internal interface on the discovered device
that first received an ZDP discovery request from the ZON utility.
NWA/WAC/WAX Series User's Guide
38