Installation And Maintenance; Preparing To Install The Sce 2000 Platform - Cisco SCE 2000 Platform SCE 2000 4/8xFE Installation And Configuration Manual

Installation and Maintenance

This chapter explains how to install a SCE 2000 platform in a rack or in a general tabletop or
workbench installation. Additionally, this chapter contains instructions for installing or replacing
the power supply units and fan modules.
Before you install, operate, or service the system, read the Regulatory Compliance and Safety
Warning
Information for the Cisco Service Control Engine. This guide contains important safety information you
should know before working with the system.
This chapter contains the following sections:
•
Preparing to Install the SCE 2000 Platform
•
Installing the SCE 2000 Platform 4-4
•
Power Supply Overview 4-11
•
Removing and Replacing a Power Supply Unit
•
Fan Module Overview
•
Replacing the Battery

Preparing to Install the SCE 2000 Platform

Before installing your SCE 2000 platform, you should consider the power and cabling
requirements that must be in place at your installation site, the equipment you need to install the
platform, and the environmental conditions your installation site must meet to maintain normal
operation. This section guides you through the process of preparing for your SCE 2000 platform
installation and the installation in a rack. The section contains the following topics:
Tools and Parts Required (on page 4-2)
•
Site Requirement Guidelines (on page 4-3)
•
OL-7826-05
4-1
4-14
4-20
4-22
Cisco SCE 2000 4/8xFE Installation and Configuration Guide
C H A P T E R 4
4-1