Cisco SCE 2000 Platform SCE 2000 4/8xFE Installation And Configuration Manual page 73

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Would you like to configure another list? [no]:
You are now prompted to assign the desired ACLs to restrict IP and Telnet access.
Restrict IP access to the SCE 2000 by assigning the appropriate ACL.
Step 9
Type the number of the ACL to be assigned to IP access and press Enter.
To accept the default ACL, press Enter.
Enter IP access-class [0]:
Restrict Telnet access to the SCE 2000 by assigning the appropriate ACL.
Step 10
Type the number of the ACL to be assigned to the Telnet interface and press Enter.
To accept the default ACL, press Enter.
Enter Telnet access-class [0]: 2
E
XAMPLE
This example illustrates a common access control scenario. Let us assume the following:
• We want to permit every station to access the SCE platform on the management port (e.g.
ping, SNMP polling etc.).
We want to restrict Telnet access to only a few permitted stations.
•
We therefore need to create two access control lists:
• For general IP access — permit access to all IP addresses.
• For Telnet — permit access to the specified IP address, and deny to all others.
ACL #1 = permit any IP address. Assign to IP access.
ACL #2 = permit access to 10.1.1.0, 10.10.10.1, deny to all others. Assign to Telnet access.
Would you like to enter the Access lists configuration menu? [no]: y
Would you like to create new Access lists or modify existing lists? [no]: y
Enter ACL number: 1
Does this entry permit access? [yes]:
Enter IP address or the word 'any' to denote any IP address: any
This entry matches every IP address, no use in adding more entries to this
list.
Would you like to configure another list? [no]: y
Enter ACL number: 2
Does this entry permit access? [yes]:
Enter IP address or the word 'any' to denote any IP address: 10.1.1.0
Enter wildcard bits: 0.0.0.0
Would you like to add another entry to this list? [no]:y
Does this entry permit access? [yes]:
Enter IP address or the word 'any' to denote any IP address: 10.10.10.1
Enter wildcard bits: 0.0.0.0
Would you like to add another entry to this list? [no]:y
Does this entry permit access? [yes]:n
Enter IP address or the word 'any' to denote any IP address: any
This entry matches every IP address, no use in adding more entries to this
list.
Would you like to configure another list? [no]:
OL-7826-05
When all ACLs have been created, press Enter.
•
1:
Cisco SCE 2000 4/8xFE Installation and Configuration Guide
Initial System Configuration
5-15