Cisco SCE 2000 Platform SCE 2000 4/8xFE Installation And Configuration Manual page 85

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
At this point, check that the Link/Active LED is green.
The state of the 10/100/1000 LED will depend on the Ethernet network settings.
Green indicates 100 Mbps and 'Off' indicates 10 Mbps.
Test connectivity. From the host that you intend to use for remote management, ping to the SCE
Step 2
2000 by typing ping and the SCE 2000 IP address, and pressing Enter (see the example, below).
Please note that only step 2 above, is performed from the remote management host (Mng port
Note
connection).
This verifies that an active connection exists between the specified station and the management
port.
The ping program sends an echo request packet to an IP address and then awaits a reply. Ping
output can help you evaluate path-to-host reliability, delays over the path, and whether the host
can be reached or is functioning.
This completes the procedures for connecting the management interfaces and for initial
configuration of the SCE 2000 platform. Proceed to the next chapter for a description of the
procedures for cabling the Fast Ethernet ports f and for configuring Fast Ethernet (FE) interface
parameters.
E
XAMPLE
The following example displays a typical ping response where the target IP address is 10.1.1.201.
C:\>ping 10.1.1.201
pinging 10.1.1.201 ...
PING 10.1.1.201: 56 data bytes
64 bytes from host (10.1.1.201): icmp_seq=0. time=0. ms
64 bytes from host (10.1.1.201): icmp_seq=1. time=0. ms
64 bytes from host (10.1.1.201): icmp_seq=2. time=0. ms
64 bytes from host (10.1.1.201): icmp_seq=3. time=0. ms
----10.1.1.201 PING Statistics----
4 packets transmitted, 4 packets received, 0% packet loss
round-trip (ms) min/avg/max = 0/0/0
OL-7826-05
:
Cisco SCE 2000 4/8xFE Installation and Configuration Guide
Connecting the Management Interface
5-27