Cisco SCE 2000 Platform SCE 2000 4/8xFE Installation And Configuration Manual page 72

Initial System Configuration
Would you like to enter the Access lists configuration menu? [no]: y
Type y and press Enter.
The Access Control Lists configuration dialog begins.
Step 2 You have the option of creating or modifying Access Control Lists, or skipping this section and
proceeding directly to assign the existing ACLs to the desired management interfaces.
Would you like to create new Access lists or modify existing lists? [no]: y
If you choose not to create or edit Access Control Lists, skip to Step 9: Configuring the Topology-
Dependent Parameters (on page 5-19).
Step 3 Type the number of the Access Control List to be configured (1 through 99) and press Enter.
Note that there is no default for this parameter.
Begin adding entries to the selected list.
Step 4
Indicate whether this entry is permitted access or denied access.
Does this entry permit access? [yes]:
Step 5 Type the IP address to be added to this list, and press Enter.
Type "any" and press Enter to include any IP address in the ACL.
Note that there is no default for this parameter.
Enter IP address or the word 'any' to denote any IP address:
Step 6 If you entered a specific IP address, enter the wildcard bits to define a range of IP addresses and
press Enter. (See Entry Formats (on page 5-13).)
To define an individual IP address, type 0.0.0.0 and press Enter.
There is no default for this parameter.
Enter wildcard bits:
Step 7 The maximum number of entries in an ACL is 20.
If the "any" option was used, no other IP addresses may be added to the list.
Would you like to add another entry to this list? [no]:y
Enter up to 20 entries as described in step 5 and step 6.
Would you like to add another entry to this list? [no]:
Step 8 When all entries are added to one list, you are asked whether you would like to create another
ACL. You may define up to 99 ACLs.
Would you like to configure another list? [no]: y
Enter up to 20 IP addresses in this new ACL, as described in step 5 and step 6.
Cisco SCE 2000 4/8xFE Installation and Configuration Guide
5-14
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
To permit access press Enter.
•
To deny access type n and press Enter.
•
To add more entries, type y and press Enter
•
When all entries have been added, press Enter
•
• To create another ACL, type y and press Enter
OL-7826-05