Cisco SCE 2000 Platform SCE 2000 4/8xFE Installation And Configuration Manual page 76

Initial System Configuration
Step 13 The maximum number of trap managers is 20.
Would you like to add another SNMP trap manager? [no]:y
Enter up to 20 trap managers as described in step 10 through step 12.
Would you like to add another SNMP trap manager? [no]:
Configure the Authentication Failure trap status.
Step 14
Enable the 'Authentication Failure' trap [no]:
Step 15 Configure the SCE enterprise trap status.
Enable the SCE enterprise traps []:
Type the name of the system administrator and press Enter.
Step 16
Note that there is no default for this parameter.
Enter system administrator contact name []:
E
XAMPLE
Following is a sample SNMP configuration, configuring one trap manager, one GET community,
and one SET community, and enabling the authentication failure trap, as well as all enterprise
traps.
Would you like to enter the SNMP configuration menu? [no]: y
Enable SNMP management? [no]: y
Enter SNMP GET community name[]: public
Enter Access list number allowing access with this community string, use '0'
to allow all: 0
Would you like to add another SNMP GET community? [no]:
Enter SNMP SET community name[]: private
Enter Access list number allowing access with this community string, use '0'
to allow all: 2
Would you like to add another SNMP SET community? [no]:
Would you like to configure SNMP trap managers? [no]: y
Enter SNMP trap manager IP address: 10.1.1.253
Enter SNMP trap manager community string: public
Enter trap manager SNMP version: 2c
Would you like to add another SNMP trap manager? [no]:
Enable the 'Authentication Failure' trap [no]: y
Enable SCE enterprise traps []: y
Enter system administrator contact name []: John Smith
Cisco SCE 2000 4/8xFE Installation and Configuration Guide
5-18
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
To add more entries, type y and press Enter
•
• When all entries have been added, press Enter
To disable the Authentication Failure trap, press Enter.
•
To enable the Authentication Failure trap, type y and press Enter.
•
To disable the SCE enterprise traps, type n press Enter.
•
To enable the SCE enterprise traps, type y and press Enter.
•
:
OL-7826-05