Cisco Network Device 2800 Introduction Manual page 69

Do not place anything on top of the router that weighs more than 10 pounds (4.5 kg), and do not stack
Caution
routers on a desktop. Excessive distributed weight of more than 10 pounds, or pound point load of
10 pounds on top could damage the chassis.
Your chassis installation must allow unrestricted airflow for chassis cooling. For placing the router on a
Caution
desktop, keep at least 1 inch (2.54 cm) of clear space beside the cooling inlet and exhaust vents.
After the router is installed, you must connect the chassis to a reliable earth ground. For the chassis
ground connection procedures, see the
Mounting a Cisco 2811 Router on a Wall
This section explains how to mount Cisco 2811 routers on a wall or other vertical surface. Mounting
Cisco 2801, Cisco 2821, and Cisco 2851 routers on a wall is not recommended.
The following warning applies to Cisco 2811 routers:
Warning This unit is intended to be mounted on a wall. Please read the wall mounting instructions carefully
before beginning installation. Failure to use the correct hardware or to follow the correct procedures
could result in a hazardous situation to people and damage to the system. Statement 248
When choosing a wall mounting location, consider cable limitations and wall structure.
Tip
Use brackets designed for 23-inch rack-mounting (shown in
Attaching Brackets to the Router for Wall Mounting
Attach the standard brackets to the chassis as shown in
each bracket.
Figure 15
OL-5786-03
Attaching the Brackets for Wall-Mounting a Cisco 2811 Router
SY S
AU X/
PW R SY S
PW R
AC T
CF
CO NS OL
CO MP AC
1 E
T FLA SH OP TIO NA
L RP S INP
UT
WA RN ING
Do Not Rem -- RP S cov
0 mu st be
ove Dur ing er
equ ipm ent ins tall ed
Net wor k AU X wh en
Op era tion is wal l-m
and an RP
oun ted
S is not
con nec ted
12V
11A
-48 V
4A
"Installing the Chassis Ground Connection" section on page
Figure
Figure 15, using the four screws provided for
100 -24 0
V~ 4A
50/ 60 Hz
Chassis Installation Procedures for Cisco 2800 Series Routers
Setting Up the Chassis
6) to wall-mount the chassis.
Screws from
accessory kit
13.
11