Chassis Grounding; Setting The Chassis On A Desktop - Cisco Network Device 2800 Introduction Manual

Setting Up the Chassis
Figure 13 Attaching the Optional Cable Management Bracket to the Cisco 2801 Router
Cable management screw
Figure 14

Chassis Grounding

After the router is installed, you must connect the chassis to a reliable earth ground. For the chassis
ground connection procedures, see the

Setting the Chassis on a Desktop

You can place Cisco 2800 series routers on a desktop or shelf. If you are placing a Cisco 2801 router on
a desktop, you must first install the four rubber feet that are supplied in the accessory kit. They provide
space for air circulation and antiskid protection. Peel the rubber feet from the adhesive strip, and stick
them onto the features marked "+" on the bottom of the chassis.
To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the
Warning
handles on modules (such as power supplies, fans, or cards); these types of handles are not designed
to support the weight of the unit. Statement 1032
Chassis Installation Procedures for Cisco 2800 Series Routers
10
Attaching the Optional Cable Management Bracket to a Cisco 2811, 2821, or 2851
Router
S
L
O
EN M0 T
3
S
L
O
T
1
Cable management bracket.
Either edge may go up. Attach
to either side of the chassis.
S
L
O
T A= ACT
2
A= FDX
S= SPE ED
A
FE 0/1 A= LIN K
F FE 0/0
A
S
S
L F
O
L
T S
0
L
PVD M1
PVD M0
AIM 1
AIM 0
"Installing the Chassis Ground Connection" section on page 13.
OL-5786-03