Cisco Network Device 2800 Introduction Manual page 184

Installing a CompactFlash Memory Card
Do not remove a CompactFlash memory card from the chassis while it is being accessed. The CF LED
Caution
blinks to indicate when flash memory is being accessed. Removing the CompactFlash memory card from
the router while flash memory is being accessed can cause damage to your router.
Step 1 Press the ejector button next to the CompactFlash memory card. The ejector button moves outward so
that it projects from the panel.
Step 2 Press the ejector button again. This ejects the CompactFlash memory card part-way out of its slot.
Pull the CompactFlash memory card out of its slot.
Step 3
Push the ejector button in until the button is flush with the bezel.
Step 4
To prevent damage to the ejector mechanism, the ejector button must remain pressed all the way in (flush
Caution
against the bezel) when not being used to eject a CompactFlash memory card.
Figure 1
SYS
PWR
Installing a CompactFlash Memory Card
To install a CompactFlash memory card, perform the following steps (see
Make sure that the ejector button is fully seated so that it does not project out from the panel.
Step 1
Note
Insert the CompactFlash memory card into the slot until it is fully seated. The ejector button remains
Step 2
flush with the panel.
Note
Removing and Installing CompactFlash Memory Cards in Cisco 2800 Series Routers
2
CompactFlash Memory Card Slot in Cisco 2800 Series Routers
AUX/ SYS
PWR ACT CF
COMPACT FLASH
Do Not Remove During Network Operation
Ejector Compact
button Flash slot
If the ejector button is projecting out from the panel, push it in until it is flush with the bezel.
If the ejector button is projecting from the panel after you insert the CompactFlash memory card,
remove the CompactFlash memory card, press the ejector button until it clicks, and reinsert the
CompactFlash memory card.
1
0
Figure 1):
OL-5793-01