Cisco Network Device 2800 Introduction Manual page 114

Installing Slot Dividers in Network Module Slots
Installing Slot Dividers in Network Module Slots
In a Cisco 2851 router, you can install a slot divider in the network module slot to reduce the slot width
from extended double-wide to extended single-wide. Use of a slot divider alone (without a filler panel)
creates a slot width suitable for an enhanced extended single-wide (NME-X) network module. Use of a
slot divider with a filler panel creates a slot width suitable for an enhanced single-wide (NME) or older
version (NM) single-wide network module.
Figure 1
Figure 1
Install slot dividers into network module slots as follows:
Insert the top rails of the slot divider between the two guide rails in the top of the network module slot.
Step 1
See
Figure 2
Step 2 Push the slot divider in until it is fully seated.
Step 3 Tighten the retention screw on the front of the slot divider with a number 1 Phillips screwdriver. See
Figure
Figure
Installing Network Modules in Cisco 2800 Series Routers
2
shows a slot divider with captive screw for the network module slot in Cisco 2851 routers.
Slot Divider for Network Module Slots
Figure 2.
Inserting a Slot Divider into a Network Module Slot
S
L
O
T
X
A= FD 3
NK
A= LI A
T
A= AC 0/ 0
EE D G E
F
S= SP
0/ 1 S
S
G E L
O
A L
T
1
F
S AI M 0
M 1
0 AI
L
PV DM
DM 1
2 PV
PV DM
3. When the slot divider is fully inserted, its front surface is flush with the panel of the router. See
4.
T
D
M
0
S
L
O
T
2
S
L
O
T
0
OL-5790-01