Cisco Network Device 2800 Introduction Manual page 158

Installing and Removing PVDMs
Figure 29
1
1
Step 3 Place the PVDM in an antistatic bag to protect it from ESD damage.
Installing a PVDM
To install a PVDM, follow these steps.
If installing only one PVDM, install it in PVDM connector 0. If installing two PVDMs, install the second
Note
one in PVDM connector 1.
Locate the PVDM connector on the system board. See
Step 1
depending on your router model, for the location of the PVDM connectors.
Orient the PVDM so that the polarization notch lines up with the polarization key on the connector. See
Step 2
Figure
Hold the PVDM at an angle and insert it carefully into the PVDM connector. Tilt the PVDM up to the
Step 3
vertical position so that the clips snap into place at both ends. See
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
30
Removing a PVDM
2
Release clips
28.
1
2 Tilt the PVDM
Figure 8, Figure
Figure
9, Figure 10, or Figure 11,
30.
OL-5792-04