Cisco Network Device 2800 Introduction Manual page 59

Chassis Installation Procedures for Cisco 2800
Series Routers
This document describes how to install your Cisco 2800 series integrated services router on a desktop
or in a rack. It includes the following sections:
•
•
•
•
To see translations of the warnings that appear in this publication, see the
Note
3800 Series Integrated Services Routers Regulatory Compliance and Safety Information
accompanied this device.
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
This unit is intended for installation in restricted access areas. A restricted access area can be
Warning
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Installing Modules and Interface Cards
Cisco routers are normally shipped with network modules, high-speed WAN interface cards (HWICs),
and voice interface cards (VICs) already installed. If you need to remove or install any of these items,
see the following product installation documents, either online or shipped with the product:
For Network Modules
•
Corporate Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
© 2005 Cisco Systems, Inc. All rights reserved.
Installing Modules and Interface Cards, page 1
Installing Internal Field-Replaceable Units (FRUs), page 4
Setting Up the Chassis, page 5
Installing the Chassis Ground Connection, page 13
Installing Network Modules in Cisco 2800 Series Routers
Cisco 2800 Series and Cisco
document that