Cisco Network Device 2800 Introduction Manual page 102

Reading System LEDs
•
•
•
•
•
Reading System LEDs
The system LEDs on the front panel of the router provide information about the power, data packet
activity, and flash memory activity. For an explanation of these LEDs see
Troubleshooting Cisco 2800 Series Routers
4
Make sure that you have a version of Cisco IOS software that supports the module. Check the
–
Cisco 2800 Series Cards and Modules
network module.
Module is recognized, but interface ports do not initialize.
Make sure that the module is firmly seated in its slot.
–
Check external cable connections.
–
Make sure that you have a version of Cisco IOS software that supports the module. Check the
–
software requirements for the affected module, which can be found in the configuration note
that shipped with the network module.
Router does not boot properly, or constantly or intermittently reboots.
Make sure that the module is firmly seated in its slot.
–
Check the router chassis or software. Refer to the
–
Terms" and the "Obtaining Technical Assistance"
Documents: Introduction and Warnings"
contact information.
Router boots, but the console screen is frozen, displays no output, or displays garbled output.
Check the external console connection.
–
Verify that the parameters for your terminal are set as follows:
–
(a) The same data rate as configured for the router (9600 baud is the default)
(b) 8 data bits
(c) 1 stop bit
(d) No parity generated or checked
Router powers on and boots only when a particular module is removed.
Check the module. Refer to the
–
"Obtaining Technical Assistance"
Introduction and Warnings"
information.
– Confirm that the Cisco IOS release installed in the router supports the card. The
Cards Installation Guide
Router powers on and boots only when a particular cable is disconnected.
– There may be a problem with the module or cable. Refer to the
Hardware Warranty Terms"
2800 Series Hardware Documents: Introduction and Warnings"
warranty and customer service contact information.
online document for software requirements for the
"Cisco 90-Day Limited Hardware Warranty
sections of the
online document for warranty and customer service
"Cisco 90-Day Limited Hardware Warranty Terms"
sections of the "Cisco 2800 Series Hardware Documents:
online document for warranty and customer service contact
lists the software requirements for each card.
and the "Obtaining Technical Assistance"
"Cisco 2800 Series Hardware
and the
Cisco Interface
"Cisco 90-Day Limited
sections of the "Cisco
online document. document for
Table 1.
OL-5789-01