Replacing the Power Supply
Figure 48
1
Secondary power conector, motherboard
Install the bezel onto the front of the chassis as follows:
Step 5
Engage the plastic tabs of the bezel into the slots in the chassis.
a.
Slide the bezel until it is centered and tight against the chassis.
b.
If you are finished installing modules, install the cover on the router. See the
Step 6
Cover" section on page
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
48
Connecting a Secondary Power Cable in Cisco 2821 and Cisco 2851 Routers
51.
2
Secondary power connector, power supply
"Installing the Chassis
2
1
OL-5792-04